Hw 130 Motor Control Shield For Arduino Datasheet Free __full__ -

The shield is designed to "piggyback" directly onto an Arduino Uno or Mega. Motor Connections Screw terminals for DC motors. Stepper 1: Uses M1 and M2 terminals. Stepper 2: Uses M3 and M4 terminals. Servo 1 & 2: Standard 3-pin headers (GND, 5V, Signal). Power Management EXT_PWR Terminals: External power input for motors.

The L293D chips can get hot. If running near 600mA, consider adding small stick-on heatsinks. hw 130 motor control shield for arduino datasheet free

// Stop digitalWrite(MOTOR_A_IA, LOW); digitalWrite(MOTOR_A_IB, LOW); delay(500); The shield is designed to "piggyback" directly onto