Icom Ic-f310 Programming Software ((top)) Link

A: Yes, the latest versions of CS-F310 are compatible. For older versions, run the software in Windows 7 compatibility mode with Administrator privileges.

The OPC-478 has a unique 8-pin modular connector. Do not confuse this with the OPC-478UC (USB version), which was used for later models like the F3G/F4G series. For the original F310, the serial interface is the standard. Icom Ic-f310 Programming Software

: You can check the radio's firmware version by holding the Up Arrow and P3 buttons while switching the power on. A: Yes, the latest versions of CS-F310 are compatible

Note: Using USB cables on modern Windows versions may require specific drivers (like or FTDI ) and setting the software to COM Port 1 . Technical Tips for Successful Programming Do not confuse this with the OPC-478UC (USB

Because the radio is End-of-Life (EOL), Icom no longer supports CS-F310 on Windows 11. Community forums like RadioReference.com and CommunicationsSupport.org are your best resources for legacy driver files.

The F310 is famous for its built-in signaling – programmed entirely in the software.

The primary software used to configure the series is the Icom CS-F300 Cloning Software . Buy Icom CS-F300 | Programming Software, DOS Version