This is the modern version with built-in Wi-Fi and support for touchscreens like the TS35. MKS DLC V2.1_001 SCH.pdf - GitHub
The first step in setting up your MKS DLC V21 is to connect the hardware. This includes:
The board uses the CH340 serial chip. Ensure the CH340 USB driver is installed on your PC before attempting to connect via USB. makerbase mks dlc v21 manual link
The is not just a file – it is your blueprint for a safe, high-performance 3D printer. The primary, authoritative, and most up-to-date link remains:
For community support and troubleshooting, users often frequent the LightBurn Software Forum or the FluidNC Wiki . This is the modern version with built-in Wi-Fi
Check your Vref on the stepper drivers; they might not be getting enough current.
A: Yes, via USB cable. The manual specifies the USB serial port is on /dev/ttyACM0 after installing the CP210x driver (note: the board uses a CH340G, not CP2102 – the manual clarifies this in the BOM). Ensure the CH340 USB driver is installed on
The official manual is the single source of truth. Use GitHub search MKS-DLC21 manual and look for the PDF in the hardware folder. No live link is guaranteed, but the path above will always lead you to the most recent version.