: When a target is detected, use the pinpoint feature (often a button) to locate the exact center of the buried object. Maintenance Tips
| Pattern | Meaning | Solution | | :--- | :--- | :--- | | 3 short beeps, then silence | Battery critically low | Replace 9V battery | | Continuous warbling (siren) | Overload – Large iron nearby | Lift coil, re-sweep higher | | 1 long beep every 10 seconds | Coil cable loose | Check connector pins | | Machine chatters constantly | Sensitivity too high | Turn Sensitivity down by 2 | Orbitor Prospector 100 Metal Detector Manual
(Note: Exact numbers can vary by production run and regional variants — consult the device label or manufacturer for precise specs.) : When a target is detected, use the
| Category | Key Features | |----------|---------------| | Modes | All-metal, Discrimination, Prospecting (Gold), Beach/Salt, Pinpoint | | Target ID | 12-segment, 0–99 numeric, ferrous bar, 3 tones | | Ground Balance | Manual, Auto (one-touch), mineralization indicator | | Coil | 10″×7″ DD waterproof (standard), 6″ DD optional | | Audio | Speaker, 3.5mm jack, vibration mode | | Display | Backlit LCD with depth, battery, sensitivity, notch pattern | | Battery | 2×9V (~25 hrs), low-battery warning | | Durability | IP54 control box, IP68 coil, telescoping aluminum shaft | | Special | Notch filter, iron mask, freq shift, depth calibration | : When a target is detected
Start in "All Metal" mode to get a feel for the ground.