V2000-c Rfid Access Control User Manual -

| Action | Command | |--------|---------| | Enter programming mode | *MasterCode# (e.g., *123456# ) | | Change master code | 00 NewCode# RepeatNewCode# | | Add RFID card | 11 CardNumber# (or present card after 11 ) | | Add PIN user (ID 1–200) | 12 UserID# PIN# | | Add card + PIN user | 13 UserID# → present card → enter PIN | | Delete single user | 14 UserID# | | Delete all users | 15# (use with caution) | | Set relay duration (1–60s) | 03 Seconds# | | Set door sensor mode (0=off,1=on) | 04 Mode# | | Exit programming | *# |

Supports WG26 for connecting external readers or controllers. www.goldbridgesz.com Programming Guide V2000-c Access Control Manual - Facebook V2000-c Rfid Access Control User Manual

| Terminal | Label | Connection | Wire Gauge (AWG) | | :--- | :--- | :--- | :--- | | 1 | +12V | Power Supply Positive (10-14V DC) | 18-22 | | 2 | GND | Power Ground / Common Negative | 18-22 | | 3 | NO | Normally Open (Magnetic Lock) | 18 | | 4 | COM | Common (Lock Relay) | 18 | | 5 | NC | Normally Closed (Electric Strike - Fail Secure) | 18 | | 6 | PUSH | Exit Button Signal (Short to GND to activate) | 22 | | 7 | SEN | Door Contact Sensor (Magnetic Reed Switch) | 22 | | 8 | AL+ | Alarm Output (+) | 22 | | 9 | AL- | Alarm Output (-) | 22 | | 10 | +12V | Reader Power (For external reader – rarely used) | 22 | | 11 | DATA0 | Wiegand Data 0 (For external reader) | 22 | | 12 | DATA1 | Wiegand Data 1 (For external reader) | 22 | | Action | Command | |--------|---------| | Enter

For further support, consult your distributor for hardware-level repairs. The V2000-c’s simplicity is its strength – there is no cloud to fail, no subscription fee, and no software to crash. Just security that works. Just security that works