Xta-7000 Temperature Controller Manual

The target temperature you want to reach (displayed in green). 2. Changing Your Target (Setting the SV) If you need to change your target temperature from Enter Setting Mode: key once. The SV display will start flashing. Adjust the Value: keys to change the numbers. Hold the keys down to speed up the counting. Save and Exit: key again to lock in your new target. 3. Tuning for Precision (The AT Feature)

Typical terminal assignments for the XTA-7000 (96x96mm panel size): Terminals 1 & 2 (Line and Neutral). Control Output (Main): Relay: Terminals 3 & 4 (Normally Open). SSR: Terminal 3 (+), Terminal 4 (-). Sensor Input: Thermocouple: Terminal 9 (+), Terminal 10 (-). RTD (3-wire): Terminals 8, 9, and 10. xta-7000 temperature controller manual

Suggestions for improvement

Full Modbus map is available in the extended manual, typically provided upon request. The target temperature you want to reach (displayed

Use Pins 8, 9, and 10 for a 3-wire setup to compensate for lead resistance. Control Output: The SV display will start flashing

The manual explains how to program temperature profiles.

You can copy and paste this directly to your website, forum, or product page.